Magnetbrytare Nano
Magnetbrytare NanoFörstora bild
Magnetbrytare Nano
Designed for DLG and HLG model gliders. Lightweight switch, less than 2g.
 
5st

 

Introduction

This switch is designed for DLG and HLG remote controlled model gliders. This power switch is super lightweight. If the cables are shortened to 10 cm, normal installation length, the total weight less than 2g. With this switch your model can be turned on or off without your need to access it internally. Just move a magnet over the switch, on the outside, and it turns on. To turn it off just pass the magnet by the switch again. The switch has an ultra low stand-by consumption in off-state. The consumption is so low that the switch can be connected to a 300mAh battery for several years without discharging it. The switch has a built-in failsafe function. It remembers its state for at least 10 sec, if disconnect from the battery. It will protects the switch against power glitch caused by bad battery connection etc.

 

Technical Data

Input voltage range: 2.6v~13v
Ultra low dropout voltage: 26mV@5A
Output current constant: 5A @ +25C ambient temperature
Output current burst: >10A
Ultra low stand-by current: 5µA (micro-ampere)
Connectors: JR-type
Wire: high-quality 0.25mm2 / AWG 23
Weight: 1.75 grams / 0.06oz (length 10cm)
Length including cables: 20 cm / 7.8 in
Dimensions: 25 x 7 x 3 mm / 0.98 x 0.28 x 0.12 in
Operational temperature range: -40C to +85C


Tillbaka